2018.2

l
Code 39 Properties group:
l
Height: Enter the Barcode height in either metric (cm/mm), inch (in) or point (pt)
values.
l
Use extended character set: Check to use the Code 39 Extended character set.
This extends the range of supported data to include the full ASCII character set.
This adds support for lower case letters (a-z) and the full range of ASCIIpunctuation
and special characters.
l
Module Width: Specifies the width of the narrow bars. Changing this value to a
higher value will generally make the Barcode bigger. The smallest Module Width is
0.19mm (high density).
l
Bar width ratio: Set the Barcode bar width.
l
Checksum: Use the drop-down to select how to deal with the Barcode
checksum:
l
Ignore: Ignore checksum calculations.
l
Auto: Add a checksum character to the Barcode if the initial value does not
validate. This is the default value.
l
Check: Verify the Barcode has a valid checksum.
l
Add: Calculate and add a checksum character to Barcode, regardless of
current value.
l
Print human readable text: Check to add a textual version of the Barcode
data.
l
Placement: Use the drop-down to select whether to place the human
readable text above or below the Barcode.
l
Font name: Use the drop-down to select the font with which to display the
human readable text.
Note
Vertically-oriented fonts (fonts whose typeface name begin with the at
(@) character) are not supported in Connect.
l
Font size: Enter a font size for the human readable text.
Page 540