2018.2

preventing background colors or elements interfering with the OMR Markings when they
are read by the Inserter.
l
Margins:
l
Same for all sides: Check so that the Left margin selection is used to set all
sides identically.
l
Left, top, right, bottom: Enter measurements for the margins on each side of
the OMR Marks.
l
Custom OMRmark sizing Tab:
If supported by the currently chosen Mark Configuration you can select a Custom OMR
size by checking the Custom OMRmark sizing checkbox.
Select from any of the following, or leave the entries blank to use default values:
l
Line length: Enter a value between 10.16mm and 20mm.
l
Line thickness: Enter a value between 0.254mm and 0.63mm.
l
Gap distance: Enter a millimeter value 2.91mm and 4.2mm.
Advanced Print Wizard navigation options
l
Preview button:Click to launch a Proof Preview window, which displays how the printed
output would look based upon the currently chosen selections.
l
Back and Next buttons:Used to navigate back and forth through all the selected options
within the Wizard. Up until the Print button is pressed, one can reverse all the way
through the wizard to return to the main selection page (the "Print Options" on page596
page) and add or remove printing options from the print run.
l
Print button: Click to produce print output according to the current settings. This can be
done at any point within the Wizard, whether or not all the options selected in the "Print
Options" on page596 page have been completed or not.
l
Cancel button:Cancels the Print Wizard, without creating any printout.
Mark Position Options
The Mark Position Options page displays a Preview of the output and the possible locations
to place the inserter marks. The initial settings are determined by the selections made within
the "Inserter Options" on page610 page.
You can move back and forward between these two pages to perfect the settings, or you could
move the inserter mark box to the desired location on the preview.
Page 519