2018.2

with an error.
For example, user.language = fr and user.country = CA will cause an error since fr-CA is not
in the list of supported Locales.
Locale selection by defining only user.language
If only user.language is defined in the install.properties file, the Installer will attempt to find a
Locale in the list which starts with the given language code. The first match is selected for
installation. If no match is found, the Installer will exit with an error.
For example:
user.language = zh, will result in an installation with the Locale zh-CN
user.language = no, will result in an error
Default Locale selection
If neither user.language nor user.country is defined in the install.properties file, the Installer will
select a default Locale:
1. If the System Locale is in the list of supported Locales, it will be selected.
2. Otherwise, if there is an entry in the list of supported Locales, which matches the System
language, it will be selected (e.g. on a fr-CA system, fr-FR is selected).
3. As last resort, the first Locale in the preinstall.ini is selected (usually that should be en-
US).
Getting the exit code of a silent installation
If getting the exit code of a silent installation is desirable, use the following procedure.
1. Create a new local folder on the machine (or VM) on which Connect shall be installed
and copy/extract the contents of the Connect ISO into this folder.
2. Open a command prompt with Administrator privileges and use the "cd" command to
access this local folder.
3. Run this command to unpack the contents of the Connect Setup executable (as a sample,
we use the PReS Connect brand):
PReS_Connect_Setup_x86_64.exe -nr -gm2 -InstallPath=".\\"
Page 47