2018.1

Note
You should also choose an Option to switch off the Finishing selection, to cater for
subset Finishing.
l
Plex rules: This fixed group allows you to set rules for sheet plexing. The choices are
Duplex, Simplex or Tumble Duplex.
You should add Printer Options for each of these Plexing Rules.
See the "Printer Options" on page625 section for how to do this.
l
Custom rules: This group does not appear by default, but can be added at any point via
the Add button.
The Rules Options. These can be selected via the icons to the right of the Rules table, or from
l
Import: Allows importation of Rules from existing Job Creation Presets and/or
Connect Templates. You will be presented with options to either Import Finishing
Settings, or Import Media Settings, based upon what is currently selected and/or
available in the Rules table. Both options allow you to select an existing Connect
Template, from which to import the settings from, whilst Finishing settings can also be
imported from Job Creation Presets. The settings will be added to those already in the
Rules table.
l
Add: This allows you to Add various options, dynamically.
What options are available is dependant upon what rule is currently selected. For
example, the Plex group does not have an option to Add Rules available to it.
1.
Add Rule: This will add a Rule that is specific to the type of option was selected
when the Add Rule was pressed. The options are as follows:
l
Media/Trays : If the Rule is being added to a Media/Trays selection, then the
Dynamic Tray Mapping Editor Dialog will be launched. This dialog allows the
setting of all necessary
l
Finishing :If the Rule is being added to a Finishing selection, then the
Dynamic Finishing Editor Dialog will be launched.
l
Plex :Add Rule is not available as an option for Plex settings.
l
Custom : If the Add Rule is selected on a Custom Group selection, then the
Dynamic Custom Element Editor Dialog will be launched. The Custom Group
Page 623