2018.1

l
Has Grouping: Becomes Yes if grouping options are set in the Grouping and
Splitting Options.
l
Page Count Splitting: Becomes Yes if page count splitting is used in the
Grouping and Splitting Options.
l
Slip Sheets: Becomes Yes if a slip sheet is set in the Grouping and Splitting
Options.
l
Options Group: These options are checked, or not, depending on the selected preset
chosen in the Configuration name.
l
Use Grouping: Check to activate the Grouping and Splitting Options page of the
wizard.
l
Apply filtering and sorting to record selection: Check to activate the Data
Filtering Options page of the wizard.
l
Include Metadata (PDF and AFP only): Check to activate the Metadata Options
page of the wizard.
l
Override Finishing Options: Check to activate the Finishing Options.
l
Next: Click to go to the next page of the Job Creation Wizard, Data Filtering Options
l
Finish: At any point during the wizard, click to save the current configurations, whatever
page you are on.
l
Cancel: At any point during the wizard, click to exit the wizard without saving changes.
Finishing Options
Use the Finishing Options page to force the use of specific printer finishing options, rather
than using any finishing options that might have been set in the Template's Media and Section
options.
These settings are only applied when producing print output. They do not modify the original
finishing options in either the Section or the Template.
Finishing settings can be set on various levels of Job Creation, such as Document Sets and
Job Segments. This allows you, for example, to staple Document Sets whilst punching holes in
Job Segments.
You can also have multiple finishing settings at the same level.
l
Finishing Options Table: This table, on the left of the Wizard page, allows you to add or
remove sections to apply the Finishing options to.
It contains the Section for which the settings are to be applied (Section, Document,
Page 541