2018.1

Repository selection
The Connect installation process requires a repository from which the installer copies (locally)
or downloads (online installation) all selected Connect products.
In Silent Installer mode, the installation process looks for the property product.repository in
the install.properties file and then proceeds with the following steps:
1. If the property exists, and its value contains an existing file location with a repository, the
installer will attempt to install from that repository.
2. If the property exists, and its value starts with http://, the installer will attempt to install from
that location. It will fail if no repository can be found at this location.
3. If none of the conditions mentioned in the previous steps are met, the installer will look
next for a local "repository" folder (located in the same folder as the running Installer
(Setup) executable file). If a repository is found, the installer will attempt to install from that
repository.
4. As a last resort, the installer will attempt to install from the default Connect Update Site
URL.
Examples
product.repository = http://192.168.79.73/Connect/Version_
01/repository
product.repository = C:\\iso\\2.0.0.39695_unpacked\\repository
Locale definition
It is possible to define the Locale which affects the installation language and installed locale for
Connect products by using the following properties in the install.properties file:
user.language
user.country
Locales supported by Connect
The Connect Setup supports a dedicated list of Locales, which is saved in the preinstall.ini file.
Each entry consists of a language tag and a country tag, formatted by the pattern:
<language>-<country>
The current list of supported Locales is found below, but it may be enhanced in future releases:
Page 45