1.8

You can even select which specific pages are to be represented (up to page 1,000), whilst
page numbers appear on the pages in the diagram and change dynamically, like everything
else.
Note
It is important to note that if Impositioning is used then the only metadata that will be
available to the job thereafter will be the metadata at Job Segment level.
When using Impositioning everything within the Segment is Impositioned, so all metadata
below the Job Segment level is lost.
The Imposition selections that can be made are as follows:
l
Sheet Size group:
l
Final Media Size: Use the drop-down to select the size of the media where the
output is printed. The size of the media should be equivalent to the initial Section
size multiplied by the number of repetitions, added with the margins and spaces
between the repetitions.
If Custom media size is selected, enter the custom Width and Height values.
Note
The Sheet Size cannot be altered if a Cover Page was selected in the
"Booklet Options" on page489 Page.
l
Orientation: Select orientation (aspect ratio) of media (Landscape or Portrait), or
allow Connect to automatically determine the proper aspect ratio (Auto-Rotate).
l
Position: Select from following options:
Page 491