1.6

For example, you could add a marking to the third page of a document by making
the selection Conditional and then setting the Condition entry to "page.nr = 3".
l
Clear Background Area: Check to add a white background to the OMR, preventing
background colors or elements interfering with the OMR Markings when they are read by
the Inserter.
l
Margins:
l
Same for all sides: Check so that the Left margin selection is used to set all sides
identically.
l
Left, top, right, bottom: Enter a measure for the margins on each side of the OMR
Marks.
l
Custom OMRmark sizing: If supported by the chosen Mark Configuration you can select
a Custom OMR size.
You can select from any of the following, or leave the entries blank to use default values:
l
Line length: Enter a value between 10.16mm and 20mm.
l
Line thickness: Enter a value between 0.254mm and 0.63mm.
l
Gap distance: Enter a millimeter value 2.91mm and 4.2mm.
Advanced Print Wizard navigation options
l
Load button: Click to select a previously created Output Creation Preset. This will change
the Advanced Print Options to match the entries contained within the Preset.
l
Preview button:Click to launch a Proof Preview window, which displays how the printed
output would look based upon the currently chosen selections.
l
Back and Next buttons:Used to navigate back and forth through all the selected options
within the Wizard. Up until the Print button is pressed, one can reverse all the way
through the wizard to return to the main selection page (the "Print Options" on page408
page) and add or remove printing options from the print run.
l
Print button: Click to produce print output according to the current settings. This can be
done at any point within the Wizard, whether or not the options selected in the the "Print
Options" on page408 page have been completed or not.
l
Cancel button:Cancels the Print Wizard, without creating any printout.
Page 356