8.8

The same will happen if you drag an output task over an unknown output task. Note that it is
impossible to drag-and-drop any task over a configured initial input or output task.
To move a task or branch using drag and drop:
1.
In PReS Workflow Process area, click the icon of the task or branch you want to move.
2. While holding down the mouse button, drag the icon task or branch over another task or
branch.
3. Release the mouse button to drop the dragged item. The dropped task or branch is
moved above the item over which it was dropped.
To duplicate a task or branch, the same method applies but with a slight difference:
1.
In PReS Workflow Process area, click the icon of the task or branch you want to
duplicate.
2.
While holding down the mouse button, press and hold down the CTRLkey and drag the
icon task or branch over another task or branch.
3.
Release the mouse button to drop the dragged item and release the CTRLkey. The
dropped task or branch is copied above the item over which it was dropped.
When you move a branch, all its tasks are also moved. When you move a conditional branch,
all the tasks appearing on the True side of the condition are also moved.
Note
You cannot drag a task or branch over an initial input task. Any input task that is dragged and
dropped over an unknown initial input task will replace it. The same is true of an output task that is
dragged and dropped over an unknown output task.
Ignoring Tasks and Branches
PReS Workflow lets you ignore individual tasks, branches or conditions.
l When a task is disabled, it is not executed when the process is run in debug mode (see
About the Debug Mode) or by PReS Workflow Service.
Page 775