8.8

To configure this communication:
1. Open penDirector setup by right-clicking on its icon in the Windows System Tray, and
selecting penDispatcher.
2. Double-click on the PlanetPress Capture entry.
3. Change the PGCStorage folder or PGCPOST URLsettings to your liking.
4. Click OK, then OKagain.
The PGCPOSTURLshould correspond to your server name or IP, Port and the HTTPAction
task of your HTTPInput, if that is what you are using.
Example:http://127.0.0.1:8080/ProcessPGC
Bluetooth Connectivity
The Anoto penDirector program can also connect directly to the pen via wireless Bluetooth and
receive PGCfiles directly through the Bluetooth link, without needing to dock the pen.
To pair penDirector with an Anoto Digital Pen:
1. Make sure that a Bluetooth dongle is present and enabled on the computer where
penDirector is installed.
2.
Note down the PINof the Anoto Digital Pen, by docking the pen and going in the Pen
settings tab of penDirector and looking at the Pen access group at the bottom of the
dialog. The default PINis 0000.
3. Undock the pen, or remove its protective cap if it is not docked. Make sure the power light
on the pen is turned on and green in color.
4.
Go in the Bluetooth tab of penDirector and click on Add Pen.
5.
Click on Search while the cap is off on the pen.
6.
When the pen is found, click on it and then click Add.
7. When asked for the PIN, enter the one noted above.
8.
Click OKto save the settings.
The settings for Bluetooth PGChandling are separate from the ones used when docking.
Through Bluetooth, only a single storage and PGCPost URLlocation can be set for all PGCs.
Page 157