8.7

l
Password: Enter the password for the user account you specified in the user
name box.
l
Confirm password: Enter the password you entered in the Password box.
l
Services start automatically: Select to start the required PReS Workflow
automatically.
3.
Click OK.
PReS Workflow applies the user account information to all the services (PReS Workflow,
PReS Fax, PReS Image, LPD input, Serial input, Telnet input, FTP output, LPR output), that
run on this computer (with the exception of PReS Messenger, which always runs under the
Local System account).
The PReS Workflow Configuration program does not test user names and passwords, but
merely associates them with the services that require them. If you enter a bad user name or
password, these services will be denied access to the selected account.
The account you choose will be used by PReS Workflow and all its services, as well as by
PReS Fax and PReS Image (only PReS Messenger is not affected, since it always uses the
Local System account). If you install PReS Fax or PReS Image on the same computer after
performing this procedure, you will have to perform it once again, so as to choose the same
account for all the installed applications.
Process Properties
To have access to the properties of a process or subprocess:
l Right-Click on the Process in the Configuration Components Area.
l Select Properties.
You can also double-click on the process to show its options.
Note
Subprocesses do not have the "General Tab" which is only used for scheduling, but they
do have the Information Tab.
Page 656