8.6

Default Configuration behavior preferences
l Use default configuration:Check to use default input and output tasks when you create
a new process. If this group is not selected, each new process you will add will begin and
end with unknown tasks.
l Default input task: Select an input task to use as the default input task when you add a
new process. Click the Configure button located to the right of this box to set the
properties of the selected input task.
l Default output task: Select an output task to use as the default output task when you add
a new process. Click the Configure button located to the right of this box to set the
properties of the selected output task.
l
Enable Undo/Redo functionality: Select this option to enable or disable the Undo
functionality. Disabling the Undo/Redo functionality frees up a lot of memory and may
thus speed up your system. The maximum number of steps performed is set in the box
below.
l
Auto Save every: Select to enable the Auto Save functionality. The auto save delay is
set in the box below (in minutes).
Notification Messages behavior preferences
Notification Messages behavior preferences control the display of certain messages and
prompts within PReS Workflow.
Preferences
l
User mismatch: Select to have PReS Workflow display a prompt when a different user
opens the application.
l
Task deletion: Select to prompt for confirmation when deleting a task.
l
Document deletion: Select to have PReS Workflow prompt for confirmation when
deleting a document.
l
Prompt on Document deletion when service is running:
l
Group of documents deletion: Select to have PReS Workflow prompt for confirmation
when deleting a group of documents from the Configuration Components pane.
l
Empty group deletion: Select to have PReS Workflow prompt for confirmation to delete
a group when you remove the last of its member objects. If you clear this option, groups
are automatically deleted when their last members are removed.
Page 681