8.6

Sending a Configuration
PReS Workflow Configuration saves entire configurations in the form of a single file. Like any
other file, configuration files may be saved and reopened, as well as rename as desired. Simply
saving a configuration has no effect on the configuration actually used by the PReS
Workflowwhen it is started. To change any currently active configuration, you must use the
Send Configuration command.
When you use the Send command, the PReS Workflow Configuration program uses the
currently opened configuration to overwrite PReS Workflow service's current configuration.
If PReS Workflow service is running when you send a new configuration, it stops and restarts
automatically with the new configuration. If the service is stopped, it will not start automatically.
To send a PReS Workflow Configuration to the local server:
1. Open the configuration you want to use as PReS Workflow’s new configuration.
2. Edit the configuration, if required.
3.
When the configuration is ready to be used, from the PReS Workflow button, choose
Send Configuration, then Send Local.
To send a PReS Workflow Configuration to a remote server:
1. Open the configuration you want to use as PReS Workflow’s new configuration.
2. Edit the configuration, if required.
3.
When the configuration is ready to be used, from the PReS Workflow button, choose
Send Configuration, then Send Remote.
Alist of available PReS Workflow servers on the local network appears.
4. Put a checkmark next to each server where the configuration should be sent.
5. Click OK.
If a server is grayed out, this may mean you do not have access to send a configuration
remotely to it. For more information, please see "Access Manager" on page656.
Note
If PReS Workflow service is paused when you send a new configuration, it will not stop
Page 604