2022.2

l
Click the tab displaying the name of the area you want to take out and move the mouse pointer so
as to drag the area away from the combined area. As you drag, a rectangle is displayed to show
the landing position. Release the mouse button when the rectangle is away from the combined
area.
l
Double-click the tab of the area you want to take out of the combined area. The area will jump out-
side of the combined area.
Attaching areas
Note: You can attach an area to a group of combined areas, as well as change combined areas
into attached areas. When attaching previously combined areas, you may find it easier to do it in
two steps: begin by taking the area out of the combined area and then try attaching it.
To attach areas:
1. Click either a title bar (separate areas) or a tab (combined areas) displaying the name of the Con-
figuration Components pane, the Object Inspector or the Messages area and move the
mouse pointer. As you drag, a rectangle is displayed to show the landing position.
2. Drag around to the edges of another area and release the mouse button when the rectangle
appears to the left or right, or above or below the other area. The rectangle should not display a
tab at its bottom, otherwise the areas will not be attached but rather combined.
3. Resize each part of the new group as desired.
Image: Attaching an area to a group of combined areas. The rectangle showing the landing position is not tabbed and
the area will therefore be moved next to the combined area.
Page 685