2022.2

configuration. These data files appear under the data mapping configuration in the Connect section of
the Configuration Components.
Setting an attached data file as a sample data file in a process
The attached data file can be used as a sample data file in a process. This sets the emulation of the pro-
cess ("About data emulation" on page54) and makes it possible to debug it (see "Debugging your
PReS Workflow process" on page88).
1. Make sure the Connect Resources section is visible by clicking the button if it appears.
2. Expand the data mapping configuration (name.OL-datamapper) by clicking the button.
3. Right-click on the data file, then click Set as sample data file.
Viewing an attached data file
1. Make sure the Connect Resources section is visible by clicking the button if it appears.
2. Expand the data mapping configuration (name.OL-datamapper) by clicking the button.
3. Double-click on the data file to open the data selector (see "The Data Selector" on page710).
Note: Double-clicking on the data file does the same thing as right-clicking on it an then selecting
Set as sample data file. Clicking Cancel instead of OK after viewing will prevent this action
from being taken.
Saving an attached data file to disk
1. Make sure the Connect Resources section is visible by clicking the button if it appears.
2. Expand the document by clicking the button.
3. Right-click on the data file, then click Save sample data file.
PlanetPress Design documents
A PlanetPress Design document is a file created with the Design module of PlanetPress Suite.
Design documents are used to produce an output, merged with data (i.e. the job file). They contain
static data such as logos, addresses and graphic formatting, as well as placeholders for data. Docu-
ments may also contain conditions and programming logic.
For more information about PlanetPress Design documents, please see the PlanetPress Design User
Guide.
Page 41