2022.2

6. When the pen is found, click on it and then click Add.
7. When asked for the PIN, enter the one noted above.
8. Click OK to save the settings.
The settings for Bluetooth PGC handling are separate from the ones used when docking. Through
Bluetooth, only a single storage and PGC Post URL location can be set for all PGCs.
Caution: Because the Bluetooth configuration only handles a single route, it is not possible to
use the Design preview patter, or the special registration pattern, using Bluetooth connectivity.
To use the preview Pattern in PlanetPress Design or use the special registration pattern, the
pen's docking station must be used.
To specify where to send the PGC files received through Bluetooth:
1. Open penDirector.
2. Go to the Bluetooth tab
3. Click on the paired pen that you want to configure
4. Specify a PGC Storage folder
5. Check the PGC POST URL option
6. Enter the URL of your PGC handling process in the box
7. Click OK to save.
PlanetPress Mobile Application
The PlanetPress Mobile application can be installed on some mobile phones and enable fast and direct
connectivity between the Anoto Digital Pen and PReS Workflow. The connectivity between the pen and
the mobile phone is done through Bluetooth, while the connectivity between the mobile phone and
PReS Workflow is through the currently active data plan (either wifi or the cell phone company's data
plan, such as 3G).
PlanetPress Capture Implementation Restrictions
This document describes the limitations of the Anoto Digital Pen & Paper Technology, especially in
regards to using it within a PReS Workflow implementation. Note that these limitations apply to any
Anoto technology implementation and not just our own.
Printer limitations
Any document printed with Capture Fields (aka Anoto Patterns) must be sent through a Laser printer.
Bubble jet printers are not supported and will most likely cause reading errors with Anoto Digital Pens.
Page 260