2020.1

l
Literal characters: Any alphanumerical character is considered a literal character and
must appear. For example, a mask of "trigger.txt" will not capture any other files than that
name.
l
Wildcards: Two wildcards are available in masks.
l
Asterisk (*): Supports any number of characters. *.txt would pick up any text file,
file*.txt would pick up any file starting with file and any characters: file1.txt,
filetest.txt.
l
Question Mark (?): Supports a single character. file?.txt would pick up File1.txt or
filea.txt, but not file13.txt or filetest.txt.
l
Brackets: Specifies a set of supported characters, or range of characters. Only one
character from the range is accepted, making this a subset of the ? wildcard.
l
Sets: [13ab] defines support for one of these 4 characters; file[13ab].txt would pick
up file1.txt , filea.txt , but not file13.txt or filea3.txt.
l
Negative Sets: [!13ab] indicates the character should NOT be part of the set. file
[!13ab].txt would pick up file2.txt and filec.txt but not file1.txt or fileb.txt (nor would
it pick up file13.txt or filea3.txt).
l
Ranges: [1-5] , [a-d] define ranges between the characters. file[1-5].txt would pick
up file1.txt and file4.txt but not file6.txt or file13.txt.
l
Negative Ranges: Negative ranges such as [!2-4] are also possible.
Note
File names containing brackets can be a hassle when attempting to capture them with a
mask and using sets or ranges. You can capture a set that contains an opening bracket (
[[] ) , but not a closing bracket as the closing bracket always ends the set or range. There
is no escape character available in masks.
Selecting a resource file in task properties
The Properties dialog of some Action, Create Content and Output tasks lets you select a file.
Depending on where the selection list appears you will have access to the Connect Resources
("Connect resources" on page39), all PlanetPress Design documents ("PlanetPress Design
documents" on page43) or only to the PlanetPress Design documents installed on a printer
queue.
Page 307