2019.1

member” at a given location in the job file (using a data selection), but the other operators
can be used to test whether or not the first string is equal to the second one, whether it is
equal or lower than the second one, etc.
The logic of text conditions can sometimes be tricky, especially if it includes variable strings, so
you should test it thoroughly.
Task properties
General Tab
l
String: If you want to test the presence of a given string at a given location, enter the
string in this box. If you want to compare two strings or perform a numeric comparison,
enter the first string in this box. Note that you can enter either a static string, a variable or a
data selection in this box. If you enter a variable, PReS Workflow will retrieve the string
from the variable before performing the comparison. If you enter a data selection, PReS
Workflow will search the job file and retrieve the string found at the referenced location
before performing the comparison.
l
Operator: Select the desired operator. Note that neither the “Is found” nor the “Is not
found” operator can be used to test XML data.
l
Convert data to uppercase before comparison: This option is only displayed when
either “Is found” or “Is not found” is selected in the Operator box. Select to prompt PReS
Workflow to convert the string to uppercase before performing the comparison.
l
Numeric comparison: This option is not displayed when either “Is found” or “Is not found”
is selected in the Operator box. Select to convert the strings from the String and
Comparison string boxes to their corresponding numeric values before performing the
comparison. If you chose an operator that compares numeric values, you should select
this option.
l
On numeric error: This option is only available when the Numeric comparison option is
selected. Select the behavior you prefer when PReS Workflow is unable to successfully
perform a numeric comparison. Select ”Return the error”, if you want the Text condition to
fail altogether. Select ”Return true”, if you want the condition to be considered True.
Select ”Return false”, if you want the condition to be considered False.
l
Location: You can only enter a location when either ”Is found” or ”Is not found” is selected
in the Operator box. If you select “at”, you also have to enter a specific line and column. If
you select “on line”, you have to enter a given line. If you select “in area”, you have to
enter a range of lines and columns. If you select “on the page”, the search area will cover
the whole data page (as defined below).
Page 476