2018.2

Redo a command
The Redo command can be used to redo commands that were just undone using the Undo
command. For example, if you used the Undo command three times in a row and immediately
thereafter decided to redo those commands, you could use the Redo command three times in a
row to redo those commands. Note that all commands in PReS Workflow Configuration can be
redone.
To redo a command:
l
From the Quick Access Toolbar, choose Redo.
Removing tasks or branches
To remove any task or branch (except Input and Output tasks), use one of the following
methods:
l
Click on the task or branch you want to delete, go to the Home tab of PReS Workflow
Ribbon and click on the Delete button in the Clipboard group.
l
Click on the task or branch you want to delete, and press the Delete (or "Del") key on your
keyboard.
l
Right-click on the task or branch you want to delete, and select Delete from the menu.
When you remove a branch, all the tasks located in that branch are also deleted. When you
delete a task, only that task is deleted.
Note
You cannot use the Delete option to remove an input or output task, but you can right-
click on them and click Cut instead. This replaces the task with an Unknown task (see
"Unknown tasks" on page566).
To delete the path below a branch crossing (instead of the path to the right of the branch):
l Press Shift+CTRL+Delete.
l
From the right-click menu, choose Edit | Delete| Delete Below the Branch.
Page 749