8.8

l
Password: Enter the password for the user account you specified in the user
name box.
l
Confirm password: Enter the password you entered in the Password box.
l
Services start automatically: Select to start the required PlanetPress Workflow
automatically.
3.
Click OK.
PlanetPress Workflow applies the user account information to all the services (PlanetPress
Workflow, PlanetPress Fax, PlanetPress Image, LPD input, Serial input, Telnet input, FTP
output, LPR output), that run on this computer (with the exception of PlanetPress Messenger,
which always runs under the Local System account).
The PlanetPress Workflow Configuration program does not test user names and passwords,
but merely associates them with the services that require them. If you enter a bad user name or
password, these services will be denied access to the selected account.
The account you choose will be used by PlanetPress Workflow and all its services, as well as
by PlanetPress Fax and PlanetPress Image (only PlanetPress Messenger is not affected, since
it always uses the Local System account). If you install PlanetPress Fax or PlanetPress Image
on the same computer after performing this procedure, you will have to perform it once again,
so as to choose the same account for all the installed applications.
Process Properties
To have access to the properties of a process or subprocess:
l Right-Click on the Process in the Configuration Components Area.
l Select Properties.
You can also double-click on the process to show its options.
Note
Subprocesses do not have the "General Tab" which is only used for scheduling, but they
do have the Information Tab.
Page 704