8.5

3. Release the mouse button to drop the dragged item. The dropped task or branch is moved above the
item over which it was dropped.
To duplicate a task or branch, the same method applies but with a slight difference:
1.
In PlanetPress Workflow Process area, click the icon of the task or branch you want to duplicate.
2.
While holding down the mouse button, press and hold down the CTRLkey and drag the icon task or
branch over another task or branch.
3.
Release the mouse button to drop the dragged item and release the CTRLkey. The dropped task or
branch is copied above the item over which it was dropped.
When you move a branch, all its tasks are also moved. When you move a conditional branch, all the tasks
appearing on the True side of the condition are also moved.
Note
You cannot drag a task or branch over an initial input task. Any input task that is dragged and dropped over an
unknown initial input task will replace it. The same is true of an output task that is dragged and dropped over an
unknown output task.
Ignoring Tasks and Branches
PlanetPress Workflow lets you ignore individual tasks, branches or conditions.
l When a task is disabled, it is not executed when the process is run in debug mode (see About the
Debug Mode) or by PlanetPress Workflow Service.
l When a branch is disabled, the whole branch including the tasks inside that branch are ignored and
not executed. In the case of conditional branches, this means that the tasks appearing on the True side
are not executed.
A task, branch or condition that was previously disabled out can be re-enabled at any time.