8.5
Table Of Contents
- Table of Contents
- Welcome to PlanetPress Workflow 8.5
- System Requirements
- Basics
- Features
- The Nature of PlanetPress Workflow
- About Branches and Conditions
- Configuration Components
- Connect Resources
- About Data
- About Documents
- Debugging and Error Handling
- The Plug-in Bar
- About Printing
- About Processes and Subprocesses
- Using Scripts
- Special Workflow Types
- About Tasks
- Task Properties
- Variable Properties
- Working With Variables
- About Configurations
- About Related Programs and Services
- The Interface
- Copyright Information
- Legal Notices and Acknowledgements
Paper quality
The PlanetPress Capture technology, when generating the Anoto Pattern, already accounts for ink
dispersion on laser printers and on general-use laser paper. Therefore, using paper that is not of the same
quality (for example, one where the dispersion rate is much higher) or the same type (reflective paper)may
not permit the pen's camera to read the pattern properly.
Pattern sizes
The absolute minimum required for an Anoto Digital Pen to read the pattern and know it's position on the
page is 7mm (1/4"). Any pattern smaller than this will not be readable. However, at 7mm width and height,
the pen can only recognize a single dot within that pattern, at the top of the field.