8.4

Edit a Task
To edit a task, you simply need to access and change its properties. You may even do it while your process
is in Debug mode (See About the Debug Mode).
To edit a task:
1. In the PlanetPress Workflow Process area, double-click the task icon.
A dialog box containing the available task properties is displayed.
2. Edit the task properties as required. Click specific tabs to see all the properties associated with the
task.
3. Click OK to close the dialog box and save the new properties.
Replacing Tasks, Conditions or Branches
You can replace existing tasks either by dropping a new task on it, or by pasting another task over it.
To replace an existing task with a new task, see Adding Tasks.
To replace an existing task with another existing task or its properties, see Cutting, Copying and Pasting
Tasks and Branches.
Note
You cannot replace a task by a branch or a condition. Trying to paste or drop a branch or condition
over a task will insert it before the task instead. The contrary is also true, you cannot replace a branch
or condition with a task.
Warning
When you replace a task, you lose all the properties you set in this task.
Remove Tasks or Branches
To remove any task or branch (except input and output tasks), use one of the following methods: