8.4
Table Of Contents
- Table of Contents
- Welcome to PlanetPress Workflow 8.4.1
- Basics
- Features
- The Nature of PlanetPress Workflow
- About Branches and Conditions
- Configuration Components
- Connect Resources
- About Data
- About Documents
- Debugging and Error Handling
- The Plug-in Bar
- About Printing
- About Processes and Subprocesses
- Using Scripts
- Special Workflow Types
- About Tasks
- Task Properties
- Working With Variables
- About Configurations
- About Related Programs and Services
- The Interface
- Copyright Information
- Legal Notices and Acknowledgements
To take an area out of a combined area, do one of the following:
l Click the tab displaying the name of the area you want to take out and move the mouse pointer so as
to drag the area away from the combined area. As you drag, a rectangle is displayed to show the
landing position. Release the mouse button when the rectangle is away from the combined area.
l Double-click the tab of the area you want to take out of the combined area. The area will jump outside
of the combined area.
To attach areas:
1. Click either a title bar (separate areas) or a tab (combined areas) displaying the name of the
Configuration Components pane, the Object Inspector or the Messages area and move the mouse
pointer. As you drag, a rectangle is displayed to show the landing position.
2. Drag around to the edges of another area and release the mouse button when the rectangle appears
to the left or right, or above or below the other area. The rectangle should not display a tab at its
bottom, otherwise the areas will not be attached but rather combined.
Note
Note that you can attach an area to a group of combined areas, as well as change combined areas into attached
areas. When attaching previously combined areas, you may find it easier to do it in two steps: begin by taking the
area out of the combined area and then try attaching it.