8.4

1. Open the configuration you want to use as PlanetPress Workflow’s new configuration.
2. Edit the configuration, if required.
3.
When the configuration is ready to be used, from the PlanetPress Workflow button, choose Send
Configuration, then Send Local.
To send a PlanetPress Workflow Configuration to a remote server:
1. Open the configuration you want to use as PlanetPress Workflow’s new configuration.
2. Edit the configuration, if required.
3.
When the configuration is ready to be used, from the PlanetPress Workflow button, choose Send
Configuration, then Send Remote.
Alist of available PlanetPress Workflow servers on the local network appears.
4. Put a checkmark next to each server where the configuration should be sent.
5. Click OK.
If a server is grayed out, this may mean you do not have access to send a configuration remotely to it. For
more information, please see "Access Manager" on page 528.
Note
If PlanetPress Workflow service is paused when you send a new configuration, it will not stop and
restart. Since PlanetPress Workflow service reads its configuration file when it starts up, when you
resume processing, PlanetPress Workflow service will continue using the old configuration.
Exit PlanetPress Workflow Configuration Program
Once you are done using PlanetPress Workflow, you can close the configuration program. It is important to
note that closing PlanetPress Workflow Configuration Program does not stop any of PlanetPress Workflow
services or stop processing.
You may exit PlanetPress Workflow Configuration Program in any of the following ways:
l
From the PlanetPress Workflow button, choose Exit.
l Click the Xat the top-right corner of PlanetPress Workflow Configuration Program
l Press ALT+F4 on your keyboard.
l
Right-click on PlanetPress Workflow Configuration Program button in your task bar, and select
Close.