2021.1

l
Output Preset: Select the appropriate Output Creation Preset to use:
l
"None": Select to prevent the execution of Output Creation.
l
"%o": Select to use a dynamic Output Preset name. Click on %o to change the
expression that determines the name of the Preset to use.
l
Preset Name: Select the appropriate Output Preset to create output with. Listed are
the Output Presets that are present in the Connect Resources (see "Connect
resources" on page40).
l
Output Management group:
l
As defined by Output Preset: Select to send the output of the job to the location
set in the Print Preset (file, printer, etc).
l
Through Workflow: Select to replace the current job file with the output produced
by the server. Every option in the Output Preset is still used, except for the output
location.
Note that when the output is separated, the current job file is not replaced with the
actual output files but with a CSV file that lists the paths to the outputted files (e.g.
“C:\Users\Administrator\Connect\filestore\3836.2859982401376467470\template_
0001.pdf,C:\Users\Administrator\Connect\filestore\3836.2859982401376467470\te
mplate_0002.pdf,…”).
l
Wait for completion: Check this option to make Workflow wait for confirmation that the
output creation task was processed, either successfully or unsuccessfully. Otherwise
Workflow will only wait for the confirmation that the job was submitted correctly to the
Output Engine.
When Output Management is set to "Through Workflow", Workflow always waits for
completion of the output creation task.
OL Connect Proxy Tab
This tab is common to all OL Connect tasks and defines where to process the jobs sent through
these tasks. When these fields are empty, they use the defaults set in the "OL Connect
preferences" on page783.
Note
Defaults are not used unless the configuration is sent to the Workflow service.
Page 597