2020.2

Table Of Contents
Taking an area out of a combined area
To take an area out of a combined area, do one of the following:
l Click the tab displaying the name of the area you want to take out and move the mouse
pointer so as to drag the area away from the combined area. As you drag, a rectangle is
displayed to show the landing position. Release the mouse button when the rectangle is
away from the combined area.
l Double-click the tab of the area you want to take out of the combined area. The area will
jump outside of the combined area.
Attaching areas
Note
You can attach an area to a group of combined areas, as well as change combined areas
into attached areas. When attaching previously combined areas, you may find it easier to
do it in two steps: begin by taking the area out of the combined area and then try
attaching it.
To attach areas:
1. Click either a title bar (separate areas) or a tab (combined areas) displaying the name of
the Configuration Components pane, the Object Inspector or the Messages area and
move the mouse pointer. As you drag, a rectangle is displayed to show the landing
position.
2. Drag around to the edges of another area and release the mouse button when the
rectangle appears to the left or right, or above or below the other area. The rectangle
should not display a tab at its bottom, otherwise the areas will not be attached but rather
combined.
3. Resize each part of the new group as desired.
Page 812