2020.2

"tag" that is added after the pattern's identification (Pattern ID). When a Pattern Sequence is
used, each Pattern Sequence can re-use each of the 20,000 available patterns. "Zones", in this
case, could refer to a specific region within a city, or a whole city or a province, whatever fits
your needs.
Pattern Sequences can be handled in 2 different ways: by attaching a Pattern Sequence to a
specific pen, or by attaching it to a specific PlanetPress Workflow process. Here is an example
for each cases, using a typical situation of a shipping company that uses PlanetPress Capture
to simplify the archiving of the client's signature on a "Confirmation of Reception" slip.
l
Pen-Based Sequences: In this case, each pen is attributed a specific pattern sequence.
When documents are printed, they are set to attribute a pattern sequence to each
document in relation to which pen it will be signed on. For example, the shipping
company may have decided to print each "route" using the route number as a pattern
sequence, and each pen is tagged (with a label) as being for use with a specific pattern
sequence also. Each morning, as drivers are attributed a route, they pick up the correct
pen and stack of paper that belong to their route before leaving.
Note
It's very important to note here that the Anoto Digital Pen has absolutely no concept of
Pattern Sequences. When "attributing" a sequence to a pen, this is fully on the
PlanetPress Workflow side, in the Capture Database. This means that if a pen is
mislabeled or someone picks up the wrong pen, this pen has absolutely no way to know
that it is writing on the wrong paper. more about this in the Contamination section below.
l
Process-Based Sequences: In this case, while documents are still printed and their
route number attributed to their pattern sequence, the pens do not have this distinction.
However, the docking station where the pens are placed at the end of the day are set to
send the pen's data to a specific process which will only handle processing for that
specific route number. In this case, one physical computer (and, presumably, printer) is
used for each route, and the driver must dock the pen in the proper docking station which
corresponds to his router number, at the end of the day.
As you may have figured out by now, we are still not actually printing more than 20,000
patterns. The only distinction here is that we are re-using patterns in separate "zones" (or, well,
sequences) and as long as pens and pages using capture patterns are not exchanged between
these zones, they act independently with their own 20,000 pattern limitation.
Page 727