2019.1

The tab also provides an option to highlight the task in "The Process area" on page769 with
the default color, set in the Preferences (see "General appearance preferences" on page659),
or the color selected or defined under Highlight color on this tab.
To revert the selected highlight color to the default color, open this tab, turn the Highlight option
off and close the dialog with the OK button; then turn highlighting back on.
Highlighting can also be turned on and off via the task's contextual menu and with the Highlight
button on the View ribbon.
Loop
Loop action tasks are used to repeat those tasks that are located after it on a given process
branch. The number of repeats can be fixed or variable, as required.
Note
The Metadata is not reset at the start of each iteration. See also: Output issues caused by
Metadata, and how to avoid them.
Task properties
General Tab
l
Number of iterations: The number of times the loop should be repeated. Every task after
the Loop action task will be repeated this number of times. The number may be static, or
use a variable (see "Variable task properties" on page607).
l
Store current iteration in Job Info #: The Job Info in which the loop's iteration should be
stored. Useful for sequential file names or conditions based on the iteration. The value of
this Variable Properties box should be a digit between 1 and 9 (see "Job Info variables"
on page597).
l
Use value of Variable/Job Info # expression: If the contents of the previous option is a
variable, its content (which is assumed to be a number between 1 and 9) will be used to
determine which Job Info number to use for the iteration number. For example if %
{myvariable} is used and contains the value 9, then Job Info 9 will store the value of the
loop's iteration.
l
Use original Data Stream every time: Select to reuse the original job file received by the
Loop action task at every iteration. If this option is not selected and if the process ends
Page 411