2018.2

1.
Make sure the PPS/PSM Documents section is visible by clicking the button if it
appears.
2. Expand the document (name.ptk) by clicking the button.
3.
Right-click on the data file, then click Set as sample data file.
Viewing an attached data file
1.
Make sure the PPS/PSM Documents section is visible by clicking the button if it
appears.
2. Expand the document (name.ptk) by clicking the button.
3. Double-click on the data file to open the data selector (see "The Data Selector" on
page658).
Note
Double-clicking on the data file does the same thing as right-clicking on it an then
selecting Set as sample data file. Clicking Cancel instead of OK after viewing will
prevent this action from being taken.
Saving an attached data file to disk
1.
Make sure the PPS/PSM Documents section is visible by clicking the button if it
appears.
2. Expand the document (name.ptk) by clicking the button.
3.
Right-click on the data file, then click Save sample data file.
Metadata
When a Design document uses Metadata, it can also be attached with the document. One
Metadata file is generated for each data file attached to the Design document. Metadata does
not appear in the Configuration Components pane but it follows the data file and can be viewed
from the Metadata tab whenever the data file is viewed through the Data Selector.
Page 42