2018.2

Anoto penDirector
The Anoto penDirector is a software driver provided as a download by Objectif Lune Inc. The
penDirector creates a bridge between the Anoto Digital Pen and a PlanetPress Capture
workflow in PlanetPress Workflow.
In order to use penDirector, it needs to be downloaded from the Objectif Lune website, on this
page. This software must be installed after PlanetPress Workflow. The setup will install a pre-
configured version of penDirector which can be immediately used with PlanetPress Capture.
The communication between penDirector and PlanetPress Workflow is either through a folder
transfer or HTTP Post communication.
To configure this communication:
1. Open penDirector setup by right-clicking on its icon in the Windows System Tray, and
selecting penDispatcher.
2. Double-click on the PlanetPress Capture entry.
3. Change the PGC Storage folder or PGC POST URL settings to your liking.
4. Click OK, then OK again.
The PGC POST URL should correspond to your server name or IP, Port and the HTTP Action
task of your HTTP Input, if that is what you are using.
Example: http://127.0.0.1:8080/ProcessPGC
Bluetooth Connectivity
The Anoto penDirector program can also connect directly to the pen via wireless Bluetooth and
receive PGC files directly through the Bluetooth link, without needing to dock the pen.
To pair penDirector with an Anoto Digital Pen:
1. Make sure that a Bluetooth dongle is present and enabled on the computer where
penDirector is installed.
2.
Note down the PIN of the Anoto Digital Pen, by docking the pen and going in the Pen
settings tab of penDirector and looking at the Pen access group at the bottom of the
dialog. The default PIN is 0000.
Page 210