2018.1

3. Undock the pen, or remove its protective cap if it is not docked. Make sure the power light
on the pen is turned on and green in color.
4.
Go in the Bluetooth tab of penDirector and click on Add Pen.
5.
Click on Search while the cap is off on the pen.
6.
When the pen is found, click on it and then click Add.
7. When asked for the PIN, enter the one noted above.
8.
Click OKto save the settings.
The settings for Bluetooth PGChandling are separate from the ones used when docking.
Through Bluetooth, only a single storage and PGCPost URLlocation can be set for all PGCs.
Warning
Because the Bluetooth configuration only handles a single route, it is not possible to use
the Design preview patter, or the special registration pattern, using Bluetooth
connectivity. To use the preview Pattern in PlanetPress Design or use the special
registration pattern, the pen's docking station must be used.
To specify where to send the PGC files received through Bluetooth:
1. Open penDirector.
2. Go to the Bluetooth tab
3. Click on the paired pen that you want to configure
4. Specify a PGCStorage folder
5. Check the PGCPOSTURLoption
6. Enter the URLof your PGChandling process in the box
7. Click OKto save.
PlanetPress Mobile Application
The PlanetPress Mobile application can be installed on some mobile phones and enable fast
and direct connectivity between the Anoto Digital Pen and PlanetPress Workflow. The
connectivity between the pen and the mobile phone is done through Bluetooth, while the
connectivity between the mobile phone and PlanetPress Workflow is through the currently
active data plan (either wifi or the cell phone company's data plan, such as 3G).
Page 162