6.0
Table Of Contents
- Capturing Data
- Overview
- Key Concepts
- Detailed Directions
- Capture Sample Data for a Document You Install on a Printer
- Capture Sample Data for a Document You Install in PlanetPress Watch
- Capture Sample Data in Windows NT
- Capture Sample Data in Windows 2000/Server 2003/XP
- Capture Sample Data in Windows Host Using a Novell Print Server
- Capture Sample Data in UNIX (Solaris)
- Capture Sample Data using an AS/400 Systems
- Capture Sample Data From a Serial Port
- Creating Triggers
- Overview
- Key Concepts
- Detailed Directions
- Implement a Trigger under Novell 3.x
- Implement a Trigger under Novell 4.x and 5.x with NDS or Bindery Printers
- Implement a Trigger under Windows NT 4.0 with TCP/IP
- Implement a Trigger under BSD Printing Systems (BSDi, FreeBSD, Linux)
- Implement a Trigger under UNIX System V (Solaris)
- Implement a Trigger and Configure an AIX 4.3 Printer
- Implement a Trigger under VMS
- Implement a Trigger with AS/400 Systems
- Prepare SAP Device Type for PlanetPress Design
- Implement a Trigger under HP 3000
- Special Printer Requirements
- ASCII Conversion Table
- CL Program for AS/400 Systems
- Index
Detailed Directions
79
The following confirmation message appears.
The object LUNE customization has successfully been created.
If the creation of the WSCST was not successful, verify that the hexadecimal code for the INITPRT and
RESETPRT strings is correct. Once you create the WSCST, you can use it in an output queue.
Use the WSCST in an Output Queue
Note that the following procedure is the same as the one described in the Capturing Data section of this
guide, except for 3 information lines.
To use the WSCST in an output queue:
1. Create the output queue using the CRTOUTQ command.