6.0

Main Menu Options
5
<PRTSETUP>Printer setup
Specifies the control language used by the Postscript printer associated with the target output queue. This
will determine the initialization and reset code that will be sent to the printer before and after the loaded
PlanetPress document.
The possible values are:
PJL
: The printer is an HP-type device that supports Printer Job Language. This is the default value.
ADOBE: The printer is an ADOBE type device.
printer-type: Specify the printer type associated with the target output queue.
<PRTDEVICE>Printer device
Specify a printer device if you want to start a printer writer associated with the target output queue. The
device must be available before the writer can be started.
The possible values are:
*NONE
: No printer is to be started. This is the default value.
printer-Monitor: Specify a printer device name to start a monitor associated with the target output
queue.
<LINK>PlanetPress document link
Specifies how the monitor will associate a corresponding PlanetPress document.
The possible values are:
*FORMTYPE
: The form type attribute of the spooled file will be used to determine the PlanetPress
document to use.
*USRDTA: The user data attribute of the spooled file will be used to determine the PlanetPress document
to use.
*BOTH: Both the form type and user data attributes will be used to associate a PlanetPress document.
<ORIGIN>PlanetPress document origin
Specifies where the PlanetPress documents are stored.
The possible values are:
*HOST
: The PlanetPress documents are stored on the iSeries and will be downloaded as requested to the
target printer.
*PRINTER: The PlanetPress documents are stored on the target printer. The documents can be stored on
the printer's hard disk, flash memory or any other means of printer storage.