2021.1

This can be done at any point within the Wizard, whether or not all the options selected in
the "Print options" on page1180 page have been completed or not.
l Cancel button:Cancels the Print Wizard, without creating any printout.
Inserter options
This page appears as part of the Advanced Print Wizard and the Output Creation Preset
Wizard.
The Inserter Options page allows the selection of a High Capacity Feeder (HCF) model.
These machines are also commonly referred to as Inserters or Folder-Inserters.
The options available on this page are dependent upon the model selected.
The options selected on this screen influence the position of the markings set on the next page:
"Mark Position Options" on page1257.
l Model: Use the drop-down to select from any previously loaded Inserter model, or use the
Browse button to select a HCF file to load a new Inserter model.
An image representing the chosen folder-inserter is displayed under the list, along with
the HCFfile details.
l Options Group:
The options available here are all Inserter dependent, and thus will change based upon
the Inserter model selection.
To see how the selected Inserter markings would look on the printed page, click the Next
button to move to the "Mark Position Options" on page1257 page, which has a preview of
the page. You can move back and forward between these two pages until you are entirely
satisfied with the selections made.
l Mark Configuration: Use the drop-down to select the type of markings to add. This
selection basically equates to the amount of area the markings will take up on the
printed page.
l Fold Type: Use the drop-down to select the type of fold to apply to the paper. This
will impact upon where on the page the markings will be placed.
l Collation level: Select whether the markings will be made at Document level, or
Document Set level.
l Print marks on back: Check to place the Inserter Marks on the rear of the page.
l Selective Inserts:If selective inserts are supported by the chosen Mark
Configuration you can select what markings to include and whether those markings
Page 1255