2020.2

Note
When creating PDF/VT-1 or PDF/X-4 output, the visible signature should be
located outside the visible page area (trimbox/bleedbox).
The Weaver engine logs a warning message if this is not the case.
The default measuring option is points (pt) but metric options (mm / cm) can be manually
selected.
l
X: Enter the horizontal distance between the left side of the page and the left side of
the signature.
l
Y: Enter the vertical distance between the top of the page and the top of the
signature.
l
Width: Enter the desired width of the signature.
l
Height: Enter the desired height of the signature.
Select which Page the signature is to be embedded in:
l
First Page
l
Last Page
l
Specific Page. Enter which page in the Page number edit field, which becomes
enabled when this option is selected.
If the output file does not contain the specified page, then the signature will be
added as an invisible signature to the PDF output file.
Advanced Print Wizard navigation options
l
Preview button:Click to launch a Proof Preview window, which displays how the printed
output would look based upon the currently chosen selections.
l
Back and Next buttons:Used to navigate back and forth through all the selected options
within the Wizard. Up until the Print button is pressed, one can reverse all the way
through the wizard to return to the main selection page (the "Print options" on page1172
page) and add or remove printing options from the print run.
l
Print button: Click to produce print output according to the current settings. This can be
done at any point within the Wizard, whether or not all the options selected in the "Print
Page 1190