2020.2

l
/ Move Up / Move Down: Moves the selected Section(s) up or down within the
table.
l
Edit ... : Brings up the Rule Editor Dialog, which can be used to construct the rule
(s) that determines whether this conditional Finishing option is to be applied or not.
l
Binding group:
l
Style: What type of Binding to request on the printer. This includes Stapled, Glued,
Stitched, Ring, Comb, Coil, amongst other options..
l
Side: Sets the side of the paper that the Binding is to occur. This includes both the
top and the bottom of the paper,
l
Location: Sets where the binding is to occur, if applicable.
The selections available here will be dependent upon the selection made in the
Binding Style. Only Stapled and Stitched bindings have a Location option
available to them.
l
Angle: Set Stapling or Stitching binding either horizontally, vertically, or at an angle
(as supported by printer).
l
Item count: Select the amount of Staples or Stitches to use. The choice is between
the default amount or selecting a specific number using the Count option.
Tip
The options available to you in reality at print time will be printer dependent,
so you will need to know the capabilities of your printer, or leave the value set
to Default.
l
Area: The area where the binding can be applied.
l
Hole making group:
Hole making options are available only to Ring, Comb (wire and plastic) and Coil Binding
Styles. The selections will need to be made at run-time based upon the types of binding
options available that the printer supports.
l
Number of holes: The number of holes to punch for the selected Binding option.
l
Pattern Catalog ID: The Catalog IDof the selected Binding option.
Page 1160