2019.2

1. Select the start of the Repeat step on the Steps pane.
2. Look for something in the data that distinguishes lines with a line item from other
lines (or the other way around). Often, a "." or "," appears in prices or totals at the
same place in every line item, but not on other lines.
3.
Select that data, right-click on it and select Add Conditional.
Selecting data - especially something as small as a dot - can be difficult in a
PDFfile. To make sure that a Condition step checks for certain data:Set the Right
operand to Value (in the Step properties pane).Make a selection in the Data Viewer
and click the Use selected text button in the Right Operand section. You will now
be able to see whether or not the proper text is extracted by the current selection.
Repeat this until you are satisfied that the proper data is being extracted.Click on
the Use selection button in the Left Operand section to fill out the coordinates.The
point of origin of each character is at the bottom left of each of them and extends up
and to the right.
In the Data Viewer, you will see a green check mark in the left margin next to each
included line and an X for other lines.
Page 266