2019.2

these options won't apply to the Additional Content added to the physical N-
Up sheet.
l
Left: Enter the distance between the left margin of the page and the Barcode, in
either metric (cm/mm), inch (in) or point (pt) values.
l
Bottom: Enter the distance between the bottom margin of the page and the
Barcode, in either metric (cm/mm), inch (in) or point (pt) values.
UPC A Properties group:
l
Height: Enter the Barcode height in either metric (cm/mm), inch (in) or point (pt) values.
l
Module Width: Specifies the width of the narrow bars. Changing this value to a higher
value will generally make the Barcode bigger.
l
Checksum: Use the drop-down to select how to deal with the Barcode checksum:
l
Ignore: Ignore checksum calculations.
l
Auto: Add a checksum character to the Barcode if the initial value does not validate.
This is the default value.
l
Check: Verify the Barcode has a valid checksum.
l
Add: Calculate and add a checksum character to Barcode, regardless of current
value.
l
Print human readable text: Check to add a textual version of the Barcode data.
l
Placement: Use the drop-down to select whether to place the human readable text
above or below the Barcode.
l
Font name: Use the drop-down to select the font with which to display the human
readable text.
Note
Vertically-oriented fonts (fonts whose typeface name begin with the at (@)
character) are not supported in Connect.
l
Font size: Enter a font size for the human readable text.
Page 1254