2019.2

through the wizard to return to the main selection page (the "Print options" on page1174
page) and add or remove printing options from the print run.
l
Print button (Advanced Print Wizard only) or Finish button (Output Creation Preset
Wizard only):
Click to produce print output/finalize the Preset according to the current settings.
This can be done at any point within the Wizard, whether or not all the options selected in
the "Print options" on page1174 page have been completed or not.
l
Cancel button:Cancels the Print Wizard, without creating any printout.
Mark Position Options
This page appears as part of the Advanced Print Wizard and the Output Creation Preset
Wizard.
The Mark Position Options page displays a Preview of the output and the possible locations
to place the inserter marks. The initial settings are determined by the selections made within
the "Inserter options" on page1190 page.
You can move back and forward between these two pages to perfect the settings, or you could
move the inserter mark box to the desired location on the preview.
Preview box:
l
The pink area displays the areas of the page where inserter marks can be positioned.
l
The small checkered box displays the current location of the inserter marks. This box is
selectable and can be dragged to the desired location within the printable (pink) areas.
If the box is placed outside the printable areas the page will display an error and prevent
attempts at leaving the page.
Below the Preview box are buttons which allow control of the Preview box. The selections that
can be made are:
l
First Page: Click to jump to the first page.
l
Previous Page: Click to move to the previous page.
l
Next Page: Click to move to the next page.
l
Last Page: Click to jump to the last page.
Page 1192