2019.2

Note
You should also choose an Option to switch off the Finishing selection, to cater for
subset Finishing.
l
Plex rules: This fixed group allows you to set rules for sheet plexing. The choices are
Duplex, Simplex or Tumble Duplex.
You should add Printer Options for each of these Plexing Rules.
l
Custom rules: The Custom group does not appear by default, but can be added at any
point via the Add button.
The Rules Options. These options can either be selected via the icons to the right of the Rules
table, or from right click context sensitive menus within the Rules table.
The options are:
l
Import: Allows importation of Rules from existing Job Creation Presets and/or
Connect Templates. You will be presented with options to either Import Finishing
Settings, or Import Media Settings, based upon what is currently selected and/or
available in the Rules table.
Both options allow you to select an existing Connect Template, from which to import the
settings from, whilst Finishing settings can also be imported from Job Creation Presets.
The settings will be added to those already in the Rules table.
l
Add: This allows you to Add various options, dynamically.
What options are available is dependant upon what rule is currently selected. For
example, the Plex group does not have an option to Add Rules available to it.
1.
Add Rule: This will add a Rule that is specific to the type of option was selected
when the Add Rule was pressed. The options are as follows:
l
Prolog : If the Rule is being added to a Prolog selection, then the Dynamic
Custom Element Editor Dialog will be launched.You should add Printer
Options for each of the Rules added. See the "Printer Options" on page1156
section for how to do this.
l
Setup : If the Rule is being added to a Setup selection, then the Dynamic
Custom Element Editor Dialog will be launched.
Page 1153