2019.1

these options won't apply to the Additional Content added to the physical N-
Up sheet.
l
Left: Enter the distance between the left margin of the page and the Barcode, in
either metric (cm/mm), inch (in) or point (pt) values.
l
Bottom: Enter the distance between the bottom margin of the page and the
Barcode, in either metric (cm/mm), inch (in) or point (pt) values.
l
Codabar Properties group:
l
Height: Enter the Barcode height in either metric (cm/mm), inch (in) or point (pt)
values.
l
Module Width: Specifies the width of the narrow bars. Changing this value to a
higher value will generally make the Barcode bigger.
l
Bar width ratio: Set the Barcode bar width.
l
Default start symbol: Use the drop-down to select the optional Barcode start
character, which defines the encoding mode.
l
Default stop symbol: Use the drop-down to select the Barcode stop character,
which defines the encoding mode.
l
Print human readable text: Check to add a textual version of the Barcode
data.
l
Placement: Use the drop-down to select whether to place the human
readable text above or below the Barcode.
l
Font name: Use the drop-down to select the font with which to display the
human readable text.
Note
Vertically-oriented fonts (fonts whose typeface name begin with the at
(@) character) are not supported in Connect.
l
Font size: Enter a font size for the human readable text.
l
Display start/stop symbols checkbox: Adds the stop/start symbols to the
Barcode text.
Page 1148