2019.1

to cater for inserter machines not currently support by a HCF, or they can be used for any non-
inserter related post processing driven by OMR marks
l
General group:
l
Include in output checkbox: This determines whether of not this Additional Content
entry should be included in the output or not.
It is checked by default for all new entries.
This option allow for "libraries" of Additional Content to be created in Presets,
libraries from which you can pick and choose what entries you wish to have
included, at time of printing.
l
Description edit box: An edit box for adding an optional Description to the
Additional Content entry.
l
Position group:
l
Orientation: Use the drop-down to select the orientation of the OMRMark added to
the page.
l
Page Side: Select whether the OMRMark will print on the front or back of page.
l
Output once per sheet:Option relates to Imposition (also known as N-Up) printing.
Select this box to have the OMRMark printed once per sheet rather than once per
document page.
Note
If Imposition options such as auto-positioning and scaling were selected,
these options won't apply to the Additional Content added to the physical N-
Up sheet.
l
Left: Enter the distance between the left margin of the page and the OMRMark, in
either metric (cm/mm), inch (in), pixel (px) or point (pt) values.
l
Bottom: Enter the distance between the bottom margin of the page and the OMR
Mark, in either metric (cm/mm), inch (in), pixel (px) or point (pt) values.
l
Options Tab:
l
Collation Level: Choices are:
l
Document: Treats each document as a group and the group and match marks
will be set based upon the start and end of a document.
Page 1084