2018.2

below the Job Segment level is lost.
Note
If Booklet Binding were selected, some of the imposition settings will be determined by
the options made within the "Booklet Options" on page1011 Page and those imposition
settings will thus be disabled on this page.
The Imposition selections that can be made are as follows:
l
Sample Page group: Use to choose a paper size for the logical page(s) which would be
printed upon the actual physical Imposition sheet. This helps in decision making
regarding what paper sizes and orientations to use, with the Sample Page shown in blue
on the white Imposition Sheet in the output preview (and validation) diagram.
Note
The logical page size can be set independently of any template open in the
Designer, allowing for output presets to be created independently from the active
template.
If a template is currently loaded in Connect Designer, the size and portrait attribute
of the first section of that template are used as defaults for the Sample Page.
As a general rule, it makes little sense to modify the Sample Page size within the
Print Wizard (as the template media size will already have been selected), but it
does make sense when creating Print Output Presets for other templates.
If no template is loaded or if the template does not have a Print section, then the
Sample Page defaults to A4 portrait.
l
Size: Use the drop-down to select the media size of the logical template page.
l
Orientation: Select orientation (aspect ratio) of the logical template page
(Landscape or Portrait).
Page 924