2018.2

l
Bottom: Enter the distance between the bottom margin of the page and the OMR
Mark, in either metric (cm/mm), inch (in), pixel (px) or point (pt) values.
l
Options Tab:
l
Collation Level: Choices are:
l
Document: Treats each document as a group and the group and match marks
will be set based upon the start and end of a document.
l
Document Set: Treats each document set as a group and the group and
match marks will be set based upon the start and end of a document set.
l
Draw Hot Spots: This adds a red rectangle around the location of each individual
mark in the output, allowing easier checking of the OMRmark logic.
l
Line Options group:
l
Line Thickness: Sets the thickness of each OMR mark line.
l
Line Length: Sets the lenght of each OMR mark line.
l
Line Spacing: Determines how the spacing between each OMR mark line will
be set. The associated control beneath the combination box will be enabled,
based upon this selection.
l
Line Per Inch: If Line Spacing is set to Lines Per Inch this option will be
enabled. It defines how many lines will print per inch.
l
Gap Distance: If Line Spacing is set to Gap Distance this option will be
enabled. It defines the size of the gap between lines; i.e. the distance
from the bottom of one OMR mark line to the top of the next.
l
Line Distance: If Line Spacing is set to Line Distance this option will be
enabled. It defines the distance from the top of one line to the top of the
next.
l
Sequence Number Range group: Allows selection of Start and Stop points for the
wrapping page sequence number in a group.
For example, a range of 2-10 would cause the sequence numbers to iterate as
follows: 2, 3, 4, 5, 6, 7, 8, 9, 10, 2, 3, 4 ...
Page 1081