2018.2

Note
If the Stack Depth is greater than the number of sheets in the entire job then
you will get a single drill sorted block that can be guillotined and stacked to
give the complete job in record order.
l
Sides selection: Select how many sides of the Imposition Sheet are to be printed
upon. Choice is between Simplex or Duplex.
l
Method selection: In 2018.2 we introduced a new imposition page order for cut &
stack impositioning that works with continuous feed devices:Stack by Column. This
option is intended for impositions with more than 1 row. It places the next page in
the next row of the same column on the current sheet, instead of in the same row
and column of the next sheet like the pre-existing Cut and Stack does.
The choices are between:
l
Cut and Stack:Any preset created in a version of Connect prior to Connect
2018.2 will default to this Layout Method. It allows total control of subsequent
Page Order choices.
l
Stack by Column: For use with continuous feed printers. This selection limits
subsequent Page Order choices to column based options only.
l
Page Order: Select in which direction to go when adding sections to the output:
l
Left to right, top to bottom
l
Right to left, top to bottom
l
Top to bottom, left to right
l
Top to bottom, right to left
l
Reverse selection: The reverse selections have been extended in Connect 2018.2,
with the addition of the Inverse page order option. The options now available are:
l
Off. Output is not reversed.
l
Stack upside down:Essentially turns the stack upside down by reversing the
output imposition page sides. The last sheet becomes the first, and in the case
of duplex imposition, the back sides become the front sides.
Page 1019