2018.2

l
/ Move Up / Move Down: Click to move the currently selected tag(s) one position up
or down.
Finishing Options
Use the Finishing Options page to force the use of specific printer finishing options, rather
than using any finishing options that might have been set in the Template's Media and Section
options.
These settings are only applied when producing print output. They do not modify the original
finishing options in either the Section or the Template.
Finishing settings can be set on various levels of Job Creation, such as Document Sets and
Job Segments. This allows you, for example, to staple Document Sets whilst punching holes in
Job Segments.
You can also have multiple finishing settings at the same level.
l
Finishing Options Table: This table, on the left of the Wizard page, allows you to add or
remove sections to apply the Finishing options to.
It contains the Section for which the settings are to be applied (Section, Document,
Document Set or Job Segment), plus the Finishing options that are to be applies, and
any Rule determining the conditions under which the Finishing settings are to be applied.
To set the details, use the following options:
l
Import Finishing: Imports the existing settings from a Connect Template.
The Template could be the current template (Import from currently template), or
some other Template (Import from template ...).
l Add: Adds a new section to apply Finishing options to. The default is to add a
new Section, but these can be changed to Document, Document Set or Job
Segment types, thereafter.
You can have multiple selections of each type, all with different criteria determining
when the Finishing options are to be applied.
l
Delete: Removes the selected Section(s) from the table.
l
/ Move Up / Move Down: Moves the selected Section(s) up or down within the
table.
l
Edit ... : Brings up the Rule Editor Dialog, which can be used to construct the rule
(s) that determines whether this conditional Finishing option is to be applied or not.
Page 1004