1.8

l
Side: Sets the side of the paper that the Binding is to occur. This includes both the
top and the bottom of the paper,
l
Location: Sets where the binding is to occur, if applicable.
The selections available here will be dependent upon the selection made in the
Binding Style. Only Stapled and Stitched bindings have a Location option
available to them.
l
Angle: Set Stapling or Stitching binding either horizontally, vertically, or at an angle
(as supported by printer).
l
Item count: Select the amount of Staples or Stitches to use. The choice is between
the default amount or selecting a specific number using the Count option.
Tip
The options available to you in reality at print time will be printer dependent,
so you will need to know the capabilities of your printer, or leave the value set
to Default.
l
Area: The area where the binding can be applied.
l
Hole making group:
Hole making options are available only to Ring, Comb (wire and plastic) and Coil Binding
Styles. The selections will need to be made at run-time based upon the types of binding
options available that the printer supports.
l
Number of holes: The number of holes to punch for the selected Binding option.
l
Pattern Catalog ID: The Catalog IDof the selected Binding option.
Advanced Print Wizard navigation options
l
Load button: Click to select a previously created Output Creation Preset. This will change
the Advanced Print Options to match the entries contained within the Preset.
l
Preview button:Click to launch a Proof Preview window, which displays how the printed
output would look based upon the currently chosen selections.
l
Back and Next buttons:Used to navigate back and forth through all the selected options
within the Wizard. Up until the Print button is pressed, one can reverse all the way
Page 794