1.8

Note
If the Stack Depth is greater than the number of sheets in the entire job then
you will get a single drill sorted block that can be guillotined and stacked to
give the complete job in record order.
l
Reverse Pages: Select this option to reverse the order of pages.
This would print the final record on the first page and the first record on the last
page.
l
Force simplex: Select this option to make the output Simplex, rather than the
Imposition default of Duplex.
Note
If Booklet Binding were selected, some of these settings will be determined by
the options made within the "Booklet Options" on page857 Page and they
cannot be altered here.
l
CropMarks group:
l
Type: Use the drop-down to select the type of Crop Marks to add to the page.
l
Page side: What side(s) of the page to put the Crop Marks.
l
Width: Select the width of the crop mark lines.
l
Offset: How much separation (if any) to leave between the vertical and horizontal
corner markings.
l
Length: Select the Length of the crop mark lines.
Advanced Print Wizard navigation options
l
Load button: Click to select a previously created Output Creation Preset. This will change
the Advanced Print Options to match the entries contained within the Preset.
l
Preview button:Click to launch a Proof Preview window, which displays how the printed
output would look based upon the currently chosen selections.
Page 789