1.7

Note
Note
To create dynamic barcodes, "Metadata Options " on page765 must first have
been set. Metadata fields are required to create the association between the
dynamic data used in the print run and the barcode.
Use the following options to configure the output Barcode settings:
l
Position group:
l
Orientation: Use the drop-down to select the orientation of the Barcode added to
the page.
l
Output once per sheet: Option relates to Imposition (also known as N-Up) printing.
Select this box to have the Barcode printed once per sheet rather than once per
document page.
Note
If Imposition options such as auto-positioning and scaling were selected,
these options won't apply to the Additional Content added to the physical N-
Up sheet.
l
Left: Enter the distance between the left margin of the page and the Barcode, in
either metric (cm/mm), inch (in) or point (pt) values.
l
Bottom: Enter the distance between the bottom margin of the page and the
Barcode, in either metric (cm/mm), inch (in) or point (pt) values.
UPC A Properties group:
l
Height: Enter the Barcode height in either metric (cm/mm), inch (in) or point (pt) values.
l
Module Width: Specifies the width of the narrow bars. Changing this value to higher
value will generally make the Barcode bigger.
l
Checksum: Use the drop-down to select how to deal with the Barcode checksum:
Page 744